When we go to the toilet, we always flush the toilet afterwards. A special mechanism allows the water present in the tank to flow into the bowl and thus empty it. Except that sometimes, the mechanism works moderately or not at all and the water continues to flow into the bowl, tirelessly.
For what the toilet does not flushstopped not and flows continuously?
If after flushing the toilet you understand that the flow of water into the bowl does not stop, then there is a problem with the flushing mechanism. There can be many reasons for this problem and it is not always necessary to call a plumber to make repairs. This could be due to a problem with the sealing of the joints, a problem with the float or even with the flush valve, among others.
How to do For Stop the flow of water and repair the flush?
First, it’s best to turn the shut-off valve off to temporarily shut off the water. This helps avoid wasting water and driving up bills. Next, you need to identify the cause of the problem. If you have a flush system embedded in the wall, it may be more difficult to repair yourself because it is difficult to access. If not, then try watching the toilet flush. To do this, you must remove the tank cover.
How to adjust the toilet float or know if it is dead ?
The float has a very important role in the toilet: it is what allows the opening and closing of the water tap because as soon as the water is at the right level, the water supply is cut off. Also, it is the float which allows the valve to open and close, to allow water to escape from the tank.
If the toilet flushes, then there may be a problem with the float mechanism or it may be incorrectly adjusted. Start by setting it first: “the adjustment is made according to the float arm: with a rod model you can twist the rod downwards; if it is a float on a column, you must adjust the height directly with the mechanism“, indicates the site Distriartisanwhich sells plumbing accessories for professionals.
If, despite a good adjustment, the water continues to flow, then the float may be filled with limescale and is working less well. It is therefore necessary to descale it: to do this, mix a liter of hot white vinegar with 1 liter of hot water and clean your float and everything else with that. Rub lightly if necessary with an old toothbrush.
Once the adjustment is made and there are no traces of limescale, the float should work. If this is not the case, then you will certainly need to contact a professional. Before doing so, check that the flush valve is tight.
How to solve a leaky flush valve problem?
There is a valve at the bottom of the tank which allows water to flow into the bowl when flushing or, on the contrary, to retain it: it is a seal. It may be incorrectly engaged, moved or broken, which will result in a leak and therefore allow water to flow into the bowl. So in the case where the water continues to flow into the bowl, remember to check how it is installed. In addition, with the accumulation of limescale around the flushing device, the flapper may become scaled and work less well. If the part is defective, then it will need to be changed. It is better to call a professional plumber for this type of repair.
If you cannot identify the problem and the leak is still continuous, then it is best to avoid repairs yourself. No need to make the situation worse and damage the flushing mechanism. Call a professional.