winter
This way there is no damage to the house
Leaves and dirt should be removed from the gutter before the first frost.
© Greg McGill / Shutterstock.com
Whether roof, rain gutters or heating: So that the house survives the winter unscathed, owners should take some precautions.
When winter is just around the corner, you should use the days before the first frost to winterize your house and garden. This prevents possible damage. Above all, you should take a close look at the roof, heating, water pipes and windows and doors.
Check roof and gutters
Even minor damage can make the roof of a house vulnerable to frost, snow and ice. It is therefore important to ensure that the roof is in perfect condition before the start of winter and to carry out any necessary repair work. Gutters that are pitted or blocked by leaves can overflow. If the water runs over the facade or through holes in the masonry, it weakens the thermal insulation of the walls or leads to stubborn mold. Therefore, the rain gutters and downpipes should be emptied and small holes closed with silicone or resin repair tape.
Seal doors and windows
Cold outside air penetrates through leaky doors and windows and heating costs rise. It therefore makes sense to check the rubber seals on all windows before the start of winter and to replace them if they are damaged. Door rugs and sealing strips prevent excessive ingress of outside air below the doors. Leaky joints between masonry and window frames, on the other hand, should only be repaired by specialists.
Take a look at the heater
The first freezing temperatures in winter are uncomfortable when the heating does not work properly. If a radiator does not warm up and you can hear gurgling noises, this is an indication of air bubbles. The air can be quickly released with the aid of a ventilation key. This improves the energy efficiency of the radiator by up to 15 percent.
Empty the water pipes
Frost can cause very costly damage to outside water pipes. Therefore, you should first turn off the shut-off valve and then turn the tap on completely so that any water residue can drain off. If you want to protect your faucet from frost, you can unscrew it afterwards.